VR Goggles: Device Setup
Device Setup
- Plug your Meta Quest 2 into the charger
- Press and hold Power button on the right side of the goggles
- Place the headset on your head (instructions for adjusting the straps )
- Locate your primary controller (the right controller with the Oculus logo )
- Follow the Meta prompts using the primary controller:
- Click the arrow button using your trigger finger
- Read the information and adjust the headset straps
- Adjust the lenses for comfort and the clearest view
Connect to eduroam
- Use the following settings:
- EAP Method: PEAP
- Phase 2 authentication: MSCHAPV2
- CA certificate: Use system certificates
- Domain: wfu.edu
- Identity: Your WFU username (everything before @ in email)
- Anonymous identity: leave blank
- Password: Your WFU password
- Click Done
- View the safety video and press Acknowledge with you primary controller
- Download and install updates if needed.
- Once any updates are installed the device may restart.
A pairing code will appear on your goggles. Remove goggles and place them to the side until you enter the code in your Meta Quest Mobile App.
- Place the headset on your head and locate your controllers
- Follow the prompts to create Guardian Boundary with the primary controller
- The Guardian Boundary is a built-in safety feature that lets you set up boundaries in VR that appear when you get too close to the edge of your play area
- Stand up with primary controller, Confirm the floor level with the primary controller, and select Confirm
- Safety tip: remember to always wear your Touch wrist straps when in VR
- Press and hold the index finger trigger and draw the roomscale boundary and then select Confirm
- Confirm the room area is clear and strive to create a 6' x 6' play area or larger
- Redraw the boundary if needed
- Press this button () on the controller to confirm the settings
Return to VR Goggles: Setup Overview for Meta Quest 2